jc46e200a20ae step pedal grill compatible with FORD F-MAX RH

jc46e200a20ae step pedal grill is a precision-engineered under-step access grille replacement for the RH side, designed to fit vehicles compatible with FORD F-MAX. This panel helps protect the lower step zone from spray, grit, and road debris, and it is often replaced when the prior part shows vibration damage, cracked edges, or deformed mounting seats after depot maneuvering and high-mileage service.

The jc46e200a20ae step pedal grill is shaped to maintain dimensional tolerances along the mounting line, supporting stable bracket alignment and consistent clearances. The surface profile supports moisture runoff and reduces dirt packing beneath the step area, which is useful in wet regional distribution routes and low-light working conditions for trucks compatible with FORD. Fitment should be confirmed by OE reference and mounting configuration before ordering.

Installation is direct-fit: remove the worn grille, clean contact points, align the fastener holes, and tighten evenly to avoid stress points. For fleet inventory planning and warehouse picking accuracy, the reference is clearly identified as JC46E200A20AE. The jc46e200a20ae step pedal grill supports repeatable service replacement without modification for compatible with FORD F-MAX maintenance cycles.

Packing weight: 0.10 KG  •  Quantity in box: 1  •  Quantity in pallet: 0

• SKU planning: keep JC46E200A20AE visible for repeat ordering compatible with FORD fleets.
• Warehouse picking accuracy: consistent reference labeling reduces mis-picks and returns.
• Transit-ready handling: panel-style component supports tidy storage and consolidation.
• Fleet maintenance readiness: suitable for scheduled step-area refresh cycles on high-mileage units.
• RH/LH pairing logic: supports access-part pairing strategies during fleet maintenance planning.

1. Preparation: park safely, apply the parking brake, and disconnect the battery.
2. Clean the step area: remove mud/grit so fasteners can be accessed.
3. Remove old grill: undo fasteners and release the panel from the bracket line.
4. Inspect mounting points: check clips/holes for wear and correct any deformation.
5. Test-fit: confirm hole alignment and consistent edge seating.
6. Install new part: position the grill and start fasteners by hand.
7. Tighten evenly: secure progressively to avoid stress points.
8. Final check: confirm stable seating and no contact with adjacent trim.

This is a direct-fit installation with plug-and-play compatibility for standard mounting points, and no special tools required for routine replacement.