81251016732 head lamp is a direct-fit replacement head lamp assembly designed to restore stable road illumination and reduce downtime for trucks compatible with MAN TGX II / TGS II (2020+ EU). Built for commercial routes and workshop turnaround, the unit supports plug-and-play compatibility (on matching connectors), stable mounting bracket alignment, and predictable fit when guide pins and mounting seats are in good condition.

81251016732 head lamp is commonly replaced when the lens becomes hazy, the housing is cracked after impact, internal fogging appears after rain wash, or vibration damage causes aim drift and uneven beam output. For best results, compare connector orientation, mounting ears, and adjustment layout against the removed lamp before final tightening, then complete an aiming check to keep safe illumination and controlled glare.

81251016732 head lamp supports distributor stocking and fleet maintenance planning with clear OE identification and single-unit packaging (Quantity in Box: 1). When ordering for ongoing service cycles, confirm side selection (LH/RH) and any levelling configuration to avoid rework and repeat handling during installation.

81251016732 head lamp is supplied with a packing weight reference of 0.10 kg and is positioned for replacement-grade commercial vehicle service where repeatable fitment, consistent visibility, and efficient warehouse picking matter for daily operations.

● OEM Number: 81251016732
● Suitable for: trucks compatible with MAN TGX II / TGS II (2020+ EU)
● Packing Weight: 0.10 KG
● Quantity in Box: 1 | Quantity in Pallet: 0

replacement direct-fit plug-and-play fleet maintenance warehouse picking

● Box packing (1 unit/box) supports safer storage and clearer SKU control
● OE-based identification improves receiving accuracy and workshop dispatch speed
● Supports fleet maintenance scheduling for trucks compatible with MAN TGX II / TGS II (2020+ EU)
● Helps distributors streamline warehouse picking and reduce mis-ship risk

Symptom-Based Replacement Indicators:

• ■ Reduced night visibility, uneven beam, or frequent aim drift
• ■ Lens haze/cracks or internal moisture/fogging after rain wash
• ■ Broken mounts or vibration causing poor alignment

Workshop Steps (Typical):

• ● Switch ignition off, secure vehicle, and disconnect the battery
• ● Remove access trim/grille as required for mounting bolts
• ● Unplug connector, inspect pins, then replace the unit on matching mounts
• ● Function-check and adjust aim/levelling after installation

For best results on trucks compatible with MAN platforms, ensure guide pin alignment and stable bracket seating before final torque, then verify beam cutoff and road illumination during a short road test.