4861341 head lamp – Compatible with IVECO Eurostar/Eurotech 1992-2002

4861341 head lamp for compatible with IVECO Eurostar/Eurotech (1992-2002)

4861341 head lamp is a direct-fit replacement headlight assembly for heavy-duty workshop repair and fleet maintenance. Built for reliable daily operation, the 4861341 head lamp helps restore clear illumination when the original unit is cracked, fogged, or leaking moisture, and it supports consistent fitment on trucks that run long-haul or distribution routes.

Application focus: left-side LHD configuration, compatible with IVECO Eurostar and compatible with IVECO Eurotech (1992-2002). This 4861341 head lamp is selected when technicians need a fast, repeatable install with reduced downtime, especially during scheduled inspection cycles and pre-trip lighting checks.

For purchasing and catalog alignment, cross references commonly used for this same fitment family include 4861329 and 500305103. (Secondary references are shown for identification during stocking and replacement planning.)

Best practice: confirm connector type and mounting points before install, then perform a final beam aim check. Replacing the complete unit with a new 4861341 head lamp can reduce glare from worn reflectors and improve visibility in rain, night driving, and frequent stop-start delivery work.

Packing weight (reference): 4.35 kg per unit
Quantity in box: 1 unit
Warehouse-friendly: barcode/label matching for faster picking and fewer returns
B2B supply support: consolidation for fleet lighting schedules and depot replenishment
Request a quote for multi-unit orders of 4861341 head lamp (bulk availability may vary by destination).

1) Park safely, switch off ignition, and disconnect the battery negative terminal.
2) Remove surrounding trim/grille (as required by the front panel layout).
3) Unplug the harness connector and check pins for corrosion or looseness.
4) Remove mounting fasteners and support the lamp during removal.
5) Install the new unit evenly, tighten to a safe torque, and reconnect the harness.
6) Test lighting functions, then complete final aiming to keep beam pattern safe.

Tip: If the vehicle is in mixed-fleet service, confirm LHD/RHD and left/right position before ordering the 4861341 head lamp.

• Aftermarket replacement component supplied for maintenance and repair use.
• Material and packaging controls are managed to support commercial transport handling and typical chemical safety restrictions (e.g., REACH-related requirements where applicable).
• Fitment control: verify left/right position and LHD/RHD configuration prior to installation; VIN-based verification is recommended for multi-variant fleets.

Compatible with IVECO (fitment reference only).