XKLAMP
RC4613W029AC Headlamp Right – Compatible with FORD F-LINE (2023-)
RC4613W029AC Headlamp Right – Compatible with FORD F-LINE (2023-)
Headlamp System Components compatible with FORD F-LINE
Direct-fit replacement lighting compatible with FORD F-LINE (2023-) | Workshop-ready supply for fleet maintenance
RC4613W029AC headlamp right compatible with FORD F-LINE (2023-) – Description
RC4613W029AC headlamp right compatible with FORD F-LINE (2023-) is a direct-fit replacement unit designed to restore dependable road illumination after lens impact, cracked housing, condensation, or broken mounting tabs caused by daily vibration and long-haul duty cycles. For workshops, this RC4613W029AC headlamp right compatible with FORD F-LINE (2023-) helps improve service efficiency by keeping fitment predictable and reducing rework during scheduled repairs.
When the original right-side lamp becomes loose, fogged, or misaligned, beam output can drop and night visibility suffers. RC4613W029AC headlamp right compatible with FORD F-LINE (2023-) is typically chosen for stable mounting geometry and consistent connector engagement, so technicians can complete installation, verify functions, and proceed to aiming checks with fewer surprises.
For picking accuracy and cross-checking during procurement, one additional reference may be used for verification only: T436300. Use VIN/spec confirmation and physical comparison where required by your workshop SOP.
After installation, confirm low/high beam performance (as applicable to your configuration), check for secure seating, and ensure the right-side housing does not contact adjacent trim. Keeping RC4613W029AC headlamp right compatible with FORD F-LINE (2023-) in depot stock can reduce downtime during seasonal inspections and route-planned maintenance.
Bulk Purchase Benefits
DIY Replacement Guide
Quick checks before replacing
- Switch off ignition; follow workshop SOP for battery isolation if needed.
- Remove surrounding trim/access panels and keep fasteners organized.
- Disconnect the lamp connector; inspect pins for corrosion or damage.
- Remove mounting bolts; support the unit to avoid stressing tabs.
- Install the new right lamp; tighten evenly and confirm panel gaps.
- Test functions and complete aiming checks per local procedure.
Compliance Statement
• Aftermarket replacement part designed to be compatible with the listed vehicle application
• Always confirm OE number, connector type, and mounting geometry before installation
• Lighting function checks and aiming must follow local regulations and workshop procedures
Replacement solutions compatible with FORD commercial trucks for fleet and workshop maintenance
© 2025. All rights reserved.
Share
