XKLAMP
PJC46E16006AJ5BRQ dirt deflector compatible with FORD F-MAX
PJC46E16006AJ5BRQ dirt deflector compatible with FORD F-MAX
Replacement-fit body parts compatible with FORD F-MAX (2018–present) | Stocking & fleet-ready supply
PJC46E16006AJ5BRQ dirt deflector – Description
PJC46E16006AJ5BRQ dirt deflector is a cabin-corner outer deflector designed to protect the lower edge of the cab from road spray and grit during long-haul route operation and depot maneuvering on compatible with FORD F-MAX (H625) 2018–present trucks. Based on OE reference PJC46E16006AJ5BRQ, it supports clean airflow around the corner area and helps reduce paint chipping and vibration damage in high-mileage service.
The PJC46E16006AJ5BRQ dirt deflector uses an impact-resistant housing with controlled dimensional tolerances, engineered to sit flush against the cab corner and maintain consistent gap control. Its surface finish is suited for wet-weather driving, adding moisture ingress protection where dirt and salt typically accumulate during regional distribution trucks work cycles.
For replacement tasks, PJC46E16006AJ5BRQ dirt deflector is intended for direct-fit installation using existing mounting points, supporting guide pin alignment and stable mounting bracket contact. This helps speed up repair and replacement workflows, improves warehouse picking accuracy when matching OE labels, and minimizes downtime—no special tools required for typical service access on compatible with FORD F-MAX builds.
For procurement and fitment control, confirm the mounting configuration against OE reference PJC46E16006AJ5BRQ before ordering. The PJC46E16006AJ5BRQ dirt deflector is commonly stocked as a LH-side item for SKU pairing (RH/LH) planning in fleet inventory planning programs supporting compatible with FORD F-MAX (H625) 2018–present.
Bulk Purchase Benefits
DIY Replacement Guide
- Prepare the vehicle (parking brake, battery disconnect).
- Remove the existing deflector by undoing fasteners and releasing clips.
- Inspect mounting points and clean contact surfaces for proper seating.
- Test-fit the new part for guide pin alignment and flush edge position.
- Tighten fasteners evenly; confirm stable mounting bracket contact.
- Check seal integrity and verify no rubbing on adjacent panels.
For service teams, PJC46E16006AJ5BRQ dirt deflector is designed for plug-and-play compatibility and direct-fit installation, helping reduce downtime with no special tools required in typical workshop conditions on compatible with FORD F-MAX.
Compliance Statement
• Built with impact-resistant housing material for commercial vehicle use
• Engineered to meet OEM dimensional tolerances for stable panel alignment
• Designed for compatibility with standard mounting points and direct-fit installation
• Fitment should be confirmed by OE reference and mounting configuration before ordering
OE reference: PJC46E16006AJ5BRQ
Position: LH (left-hand side)
Application: Compatible with FORD F-MAX (H625) 2018–present.
