• JC4613W030AG Headlamp Left – Compatible with FORD F-MAX H625 (2018-) XKLAMP
  • JC4613W030AG Headlamp Left – Compatible with FORD F-MAX H625 (2018-) XKLAMP
  • JC4613W030AG Headlamp Left – Compatible with FORD F-MAX H625 (2018-) XKLAMP
1 3

XKLAMP

JC4613W030AG Headlamp Left – Compatible with FORD F-MAX H625 (2018-)

JC4613W030AG Headlamp Left – Compatible with FORD F-MAX H625 (2018-)

Headlamp Assembly (Left) compatible with FORD Trucks

Direct-fit replacement headlamp compatible with FORD F-MAX H625 (2018-) | Built for fleet, workshop, and long-haul use

Description

Primary OE: JC4613W030AG (Left headlamp assembly) compatible with FORD F-MAX H625 (2018-). This replacement headlight is designed for direct-fit installation, stable mounting, and consistent beam output after wear, impact damage, lens haze, or broken tabs.

Secondary reference (for cross-check only): T418578

Typical replacement triggers include reduced illumination, moisture ingress, cracked lens, loose alignment, or intermittent DRL/indicator performance caused by vibration and connector fatigue. For best results, confirm your truck spec and compare connector type and bracket geometry before installation.

JC4613W030AG left headlamp assembly compatible with FORD F-MAX H625 (2018-) front view JC4613W030AG left headlamp assembly compatible with FORD F-MAX H625 (2018-) installed reference

Bulk Purchase Benefits

MOQ (B2B)
1 Unit
Supports trial orders & service stock
Workshop efficiency
Direct-Fit
Reduced downtime during scheduled maintenance
Fleet readiness
Stable Supply
Ideal for depot & route-based replacement planning
Packaging
Protected
Safer transit for lenses & mounting points

DIY Replacement Guide

!
Symptom-Based Replacement (visibility drop, condensation, broken tabs, unstable aim)

Quick checklist (workshop-friendly)

!
Dimming / uneven light output during night routes
!
Lens fogging / water ingress after rain or wash
!
Loose housing, cracked brackets, or broken mounting points
  1. Switch off ignition; follow workshop SOP for battery isolation if required.
  2. Remove front trim / access panels as needed; keep fasteners organized.
  3. Disconnect the headlamp connector; inspect pins for corrosion and heat marks.
  4. Remove mounting bolts; support the lamp to avoid stressing tabs.
  5. Install the new left headlamp; tighten evenly and confirm panel gaps.
  6. Reconnect; verify low/high beam, DRL/indicator function (if applicable) and aim alignment.
  7. Road-test in safe conditions and re-check fixation after initial vibration cycle.

Compliance Statement

Usage & responsibility notice

• This product is an aftermarket replacement designed to be compatible with the listed vehicle application
• Always verify OE number, connector type, and mounting geometry before installation
• Light aiming and roadworthiness checks must follow your local regulations and workshop procedures

Application: Left headlamp assembly compatible with FORD F-MAX H625 (2018-)

Ordering tip: If your truck has prior front-end repairs, compare bracket positions to avoid mismatch.

Important Note: This page provides fitment guidance only. Final compatibility should be confirmed using VIN and physical part comparison before purchase.

Replacement solutions compatible with FORD trucks for fleet and workshop maintenance

Technical Notes Distributor Resources Fitment Support

© 2025. All rights reserved.

View full details