500340695 turn signal lamp – Compatible with IVECO Eurocargo I/II/III 1970-2008 & Eurofire 1991

The 500340695 turn signal lamp is a direct-fit replacement lighting unit used to restore clear indicator performance on commercial vehicles. When the original lamp is cracked, cloudy, or loose after vibration and road debris exposure, replacing it helps keep lane-change and turning signals visible on a compatible with IVECO application. This is a practical replacement choice for fleet maintenance where stable lighting reduces repeat workshop visits.

Service replacement is commonly required when moisture enters the housing, connector pins oxidize, or intermittent illumination appears after bumper repairs. Installing a correctly fitting 500340695 turn signal lamp supports steady light output and helps maintain predictable daily operation. For a compatible with IVECO fitment check, confirm the lens profile, mounting holes, and connector orientation against the removed unit before installation.

Application reference (catalog-style): compatible with IVECO Eurocargo I (TRUCK, EU, 1991), compatible with IVECO Eurocargo II (TRUCK, EU, 2003), compatible with IVECO Eurocargo III (TRUCK, EU, 2008), and compatible with IVECO Eurofire (TRUCK, EU, 1991). It is also listed for compatible with IVECO bus series (BUS, EU, 1970) where configuration differences may exist—final confirmation should be done by physical comparison of the lamp body and connector pins.

Logistics for B2B supply: packing weight 0.33 KG, quantity in box 1, quantity in pallet 110. One additional OE reference for identification only: 4855967. Please verify this cross-reference by photos, mounting pattern, and connector layout.

MOQ: 50 units
B2B Terms: NET 30
Volume Pricing: >100 units: 12% discount
Packing: 1 pc/box | Weight: 0.33 KG | Pallet: 110

■ Symptom-Based Replacement (turn signal lamp)
■ Cracked or cloudy lens / moisture inside housing
■ Flicker or intermittent illumination from vibration or connector oxidation
■ Loose fitment after bumper repair or minor impact

■ Basic Workshop Steps
1) Disconnect power and inspect connector pins for oxidation
2) Remove fasteners, compare mounting holes and lamp orientation (LH/RH), then install the replacement
3) Confirm sealing and stable fit, then test for steady illumination

Aftermarket replacement part statement (service use).
• Designed for commercial vehicle lighting replacement and routine workshop maintenance.
• Traceability and packing specifications available upon request for B2B orders.
• Fitment must be verified by mounting position, connector type, and lens profile before installation.

Compatible with IVECO Eurocargo I/II/III (1991-2008) and compatible with IVECO Eurofire (1991); other configurations require physical verification.