324835 mudguard compatible with FORD F-MAX – Direct Fit

324835 mudguard is a precision-engineered replacement designed to fit applications compatible with FORD F-MAX, supporting stable wheel-arch coverage in high-mileage service. Referencing part numbers JC46E20040BB57MC and T324835, it helps reduce splash and debris exposure and supports cleaner arch-area service intervals.

The 324835 mudguard is shaped to maintain dimensional tolerances along the arch profile while using an impact-resistant housing approach for daily commercial service. The contour supports moisture ingress protection at contact edges and helps control splash spread in low-light working conditions. Its interface is designed around stable mounting bracket geometry, supporting consistent fitment for vehicles compatible with FORD operating in wet weather and road-debris exposure.

Technicians often choose the 324835 mudguard because installation is direct-fit: clean the mounting surface, confirm guide pin alignment (if present), and keep the sealed connector interface area and wiring harness match unobstructed. Tighten fixings evenly to avoid stress points, then verify clearance with a quick steering lock-to-lock check. This replacement 324835 mudguard supports stable positioning during long-haul route operation where constant vibration and spray can loosen older wheel-arch parts.

For fleet inventory planning, clear reference labeling improves warehouse picking accuracy and reduces returns when ordering for compatible with FORD F-MAX. Keep both references visible in your system for fast cross-checking: JC46E20040BB57MC and T324835. Fitment should be confirmed by reference number and mounting configuration before ordering.

Packing weight: 0.10 KG  •  Quantity in box: 1  •  Quantity in pallet: 0

• SKU planning support: map stock by T324835 and JC46E20040BB57MC for repeat ordering compatible with FORD fleets.
• Warehouse picking accuracy: clear numbering reduces mis-picks and speeds dispatch for distribution centers.
• Transit-ready handling: single-piece part supports tidy bin storage and safer consolidation.
• Fleet maintenance readiness: useful for planned replacement cycles on regional distribution trucks.
• Stable aftermarket supply: supports consistent replenishment for workshops servicing compatible with FORD F-MAX.

1. Preparation: park on level ground, apply the parking brake, and disconnect the battery.
2. Access: turn steering for easier wheel-arch access and remove packed debris.
3. Remove old part: remove fasteners/clips and release the mudguard from the mounting points.
4. Inspect the area: check the stable mounting bracket seats for wear and confirm no cracked tabs remain.
5. Check install points: verify guide pin alignment and keep nearby wiring paths clear.
6. Install the new part: align holes, start fixings by hand, then seat the part evenly.
7. Tighten evenly: secure fasteners progressively to avoid stress points and keep consistent gaps.
8. Seal check: confirm edges sit flush to support moisture control around the wheel area.
9. Function check: steer lock-to-lock and confirm no rubbing or movement.
10. Fleet note: record JC46E20040BB57MC / T324835 for repeat procurement.

This is a direct-fit installation with plug-and-play compatibility for standard mounting points, and no special tools required for routine replacement.