0008112907 is a left, upper mirror arm upper cover designed to fit mirror arm trim configurations on trucks compatible with MERCEDES-BENZ Atego (from 1998), compatible with MERCEDES-BENZ Axor (from 2001), compatible with MERCEDES-BENZ Axor 2 (from 2004), compatible with MERCEDES-BENZ Atego 2 (from 2004), and compatible with MERCEDES-BENZ Atego 3 (from 2013). Fitment should be confirmed by OE reference and mounting configuration before ordering.

OE references covered in this listing: 0008112907, A0008112907. This part is typically used to protect and finish the upper section of the mirror arm area, helping reduce exposure of mounting points to splash, grit, and routine wash moisture.

In workshop practice, position-specific trim pieces are controlled by OE reference and clip layout. Compare the removed cover to the replacement by clip positions, seating edges, and contact surfaces before pressing into place. A flush, stable fit helps prevent rattling and keeps the mirror arm area tidy during daily vibration and door cycles.

Packing details: packing weight 0.06 KG, quantity in box 1, quantity in pallet 720. Use OE-referenced labeling to improve warehouse picking accuracy for left/upper variants.

• Fleet inventory planning: OE-led stocking for 0008112907 helps reduce downtime during trim service and mirror arm inspections.
• High pallet density: 720 units per pallet supports stable aftermarket supply for depots and distributors.
• Light handling: packing weight 0.06 KG supports efficient storage, picking, and consolidated shipping.
• SKU control: 1 unit per box helps prevent mixing left/right or upper/lower position variants.
• Improved warehouse picking accuracy when both references are shown on labels: 0008112907 and A0008112907.

• Confirm the position: this listing is for Left, Upper.
• Inspect the existing cover for cracked edges, missing clips, looseness, or poor seating after minor impacts.
• Release clips evenly and remove the old cover carefully to avoid damaging adjacent trim.
• Clean the seating area, align clip locations, and press into place with even pressure until fully seated.
• Final check: confirm the cover sits flush and does not rattle during door operation and a short vibration test drive.

This product page is written for aftermarket identification and commercial vehicle service use. Selection should be controlled by OE reference and verified against the physical mounting configuration on the vehicle.

• Identification: match by OE references 0008112907 and A0008112907.
• Position control: left, upper configuration; confirm clip layout and seating edges before installation.
• Designed for commercial vehicle use and engineered for compatibility when correctly installed.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

Compatible with MERCEDES-BENZ Atego, MERCEDES-BENZ Atego 2, MERCEDES-BENZ Atego 3, MERCEDES-BENZ Axor, MERCEDES-BENZ Axor 2.