20360807 small mirror main body lh – Compatible with VOLVO

20360807 small mirror main body lh – Description

20360807 small mirror main body lh is designed to fit a small auxiliary mirror housing main body compatible with VOLVO trucks when matched by OE reference and mounting configuration. Fitment should be confirmed by OE reference and mounting configuration before ordering. Use OE reference 20360807 to support accurate picking and reduce mismatch risk in multi-vehicle fleets.

The 20360807 small mirror main body lh is typically selected when the housing is cracked, the retention points are worn, or the mirror assembly shows vibration from poor seating. A correct match should sit flush along the perimeter, hold firmly at the clip points, and maintain stable positioning under vibration typical of heavy-duty routes. Confirm the left-hand (LH) side on the vehicle and verify the mounting faces against the removed part before installation.

For workshop efficiency, keep the primary label as 20360807 small mirror main body lh and record the OE reference on the job card for repeat ordering. Where fleets run mixed mirror systems, physical comparison of outline, clip geometry, and mounting configuration remains the most reliable method for selection.

Bulk Purchase Benefits

Fleet stocking: keep exterior mirror housing parts on hand to reduce downtime after minor impacts.

Warehouse control: store under OE reference 20360807 for fast picking and consistent internal matching.

Export-ready support: carton labeling by OE reference improves receiving, shelf counting, and workshop kitting.

DIY Replacement Guide

■ Symptom-Based Replacement

■ Cracked housing, broken clips, or loose seating on the small mirror assembly

■ Vibration at speed, rattling noise, or visible gaps around the housing edges

■ Water/spray exposure marks due to damaged or missing housing coverage

Direct-fit workshop steps (LH)

1) Confirm LH position and match OE reference 20360807 to the removed part.

2) Remove the damaged housing carefully; clean seating faces and inspect clip seats for distortion.

3) Align retention points and press evenly until fully seated; re-check uniform edge gaps.

Finish with a short stability check: no special tools required, plug-and-play compatibility, and direct-fit installation apply when OE reference and mounting configuration match.

Compliance Statement

Material performance is specified for commercial vehicle exterior use, supporting durability under vibration, temperature changes, and wet-road exposure.

Design intent supports consistent seating and alignment of visibility-related mirror housing components when installed correctly, without claiming certification or any approval marking.

Installation compatibility must be verified by OE reference and physical confirmation of outline, clip layout, and mounting configuration on the removed part.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

Compatible with VOLVO (all listed OE references).