81251016814 head lamp – Description

81251016814 head lamp is a commercial-duty replacement head lamp assembly engineered for stable mounting alignment and dependable road visibility on vehicles compatible with MAN TGX / TGS / TGM / TGL (2020-on, EU). It is a practical service option when the original unit shows lens haze, housing damage, internal moisture/fogging, or mounting wear that leads to vibration and beam aim drift during daily fleet operation.

81251016814 head lamp supports workshop-friendly replacement because fitment accuracy depends on matching the removed unit’s connector layout, sealing surfaces, and mounting tabs before final tightening. For receiving and inventory control, keep OE identification clear in your picking process and perform a functional check after installation (position/low/high and indicators where applicable), followed by a beam aim/levelling verification to maintain safe night driving visibility and controlled glare.

81251016814 head lamp is supplied as a single-unit pack (Quantity in Box: 1) with lightweight handling (Packing Weight: 0.10 kg), helping reduce handling damage risk and improving dispatch speed for distributors and fleet stores. This listing also references these cross numbers for identification only: 81251016820 and 81251016822. Always verify by VIN and the removed part before ordering.

81251016814 head lamp is suitable for planned maintenance schedules and accident repair workflows where direct-fit replacement, consistent sealing, and repeatable installation results matter. After installation, confirm the unit seats flush with surrounding panels to help reduce water ingress and vibration-related stress over time, especially for long-haul routes and frequent wash cycles.

replacement direct-fit fleet maintenance workshop ready all-weather sealing

● Single-unit box packing improves warehouse counting and picking accuracy
● OE-based identification supports faster receiving and workshop dispatch
● Suitable for distributor stocking and planned fleet replacement cycles
● Consolidation-friendly for B2B logistics lanes (labeling/packing support on request)

Symptom-Based Replacement Indicators:

• ■ Reduced brightness, uneven beam pattern, or frequent aim drift
• ■ Condensation/fogging inside the lamp after rain or washing
• ■ Cracked lens/housing or broken mounting points
• ■ Intermittent lighting caused by connector fatigue

Workshop Steps (Typical):

• ● Switch ignition off, secure vehicle, disconnect the battery
• ● Remove access trim/grille as required for mounting bolts
• ● Unplug connector, inspect pins/seal, then replace the unit on matching mounts
• ● Function-check and adjust aim/levelling after installation

81251016814 head lamp replacement is typically straightforward when the connector design, mounting alignment, and sealing surfaces are matched to the removed unit.