20360807 mirror body lh – Compatible with VOLVO

20360807 mirror body lh is designed to fit vehicles compatible with VOLVO as a small mirror housing main body for the left-hand side (LH), helping restore proper cover seating and stable mounting when the OE reference and mounting points match the removed unit. OE reference: 20360807. Fitment should be confirmed by OE reference and mounting configuration before ordering.

In daily fleet service, a cracked or distorted housing can lead to vibration, wind noise, and water ingress around the small mirror area. The 20360807 mirror body lh supports a clean exterior profile and consistent alignment by protecting the mirror body interface and maintaining even edge gaps, which helps keep the auxiliary mirror stable on long-haul and mixed urban routes.

For installation, compare the outline, clip geometry, and contact faces to the removed part, then seat the housing evenly without forcing tabs. The 20360807 mirror body lh should sit flush along the perimeter; after fitting, verify mirror adjustment stability and confirm there is no rattle during a short road test.

For purchasing control, label bins with the primary OE and record LH orientation on the job card to avoid side mix-ups in mixed inventories. Keeping 20360807 mirror body lh available as a fast-moving exterior item can reduce downtime after minor impacts, especially when workshop throughput depends on quick pick-and-fit mirror parts.

Warehouse accuracy: store and pick by OE reference 20360807 to reduce mis-issues across mixed fleets.

Workshop readiness: keeping LH small mirror housing items in stock supports faster turnaround after minor impacts and trim loss.

Order clarity: list “LH” and confirm mounting configuration in internal notes to avoid left/right confusion during kitting.

Symptom-Based Replacement

■ Cracked housing surface, broken clips, or loose seating on the small mirror assembly

■ Vibration at speed, rattling noise, or visible gaps around the housing edges

■ Water/spray marks around the mirror interface after wet-road operation

Service steps (LH)

1) Confirm LH orientation and match OE reference 20360807 to the removed housing.

2) Remove the damaged housing carefully; clean seating faces and check clip seats for distortion or debris.

3) Install the new housing by aligning retention points and pressing evenly until fully seated.

4) Seal integrity check: confirm uniform edge gaps and no pathways for water ingress.

5) Function check: confirm mirror adjustment stability and verify there is no vibration or rattle on a short test drive.

6) Fleet note: record OE reference and LH position on the job card for repeat ordering.

End check: no special tools required, plug-and-play compatibility, and direct-fit installation apply when OE reference and mounting configuration match.

Material performance is specified for commercial vehicle exterior use, supporting durability under vibration, temperature changes, and wet-road exposure.

Design intent supports stable mirror housing alignment consistent with ECE visibility category requirements, without claiming certification or any approval marking.

Installation compatibility must be verified by OE reference and physical confirmation of outline, clip layout, and mounting configuration on the removed part.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

OE & Mounting Verification

Compatible with VOLVO.