0028118933 mirror glass compatible with MERCEDES-BENZ

0028118933 mirror glass is a precision-engineered replacement mirror glass designed to fit vehicles compatible with MERCEDES-BENZ ACTROS MP4, ANTOS and AROCS when the OE reference and mounting configuration match. Fitment should be confirmed by OE reference and mounting configuration before ordering. Based on OE references 0028118933 and related numbers used in parts catalogues, it supports clear rearward visibility for lane positioning, depot maneuvering and reversing in high-mileage service.

The 0028118933 mirror glass is typically selected after vibration damage, surface scratching, edge chipping or reduced clarity that affects low-light working conditions. The glass curvature and viewing geometry are built to maintain stable sight lines, while the backing interface is designed around tight dimensional tolerances for secure seating. For cross-checking, this item is commonly referenced alongside 0028116333, A0028118933, and A0028116333.

During service replacement, technicians usually compare the removed unit to the new glass by checking outline shape, clip/adhesive interface and guide point alignment before pressing it into place. This helps preserve moisture ingress protection around the edge and supports consistent fitment on regional distribution trucks operating frequent stops and long-haul route operation. After installation, verify stable seating and confirm the viewing angle remains steady under road vibration.

For warehouse control, 0028118933 mirror glass is packed 1 per box with a packing weight of 1.34 KG (pallet quantity not specified in this record). Keeping the full OE reference set printed on the same bin label improves warehouse picking accuracy and reduces mix-ups across similar mirror variants in fleet inventory planning.

• SKU planning: group the OE set (0028118933 / 0028116333 / A0028118933 / A0028116333) to simplify depot stocking.
• Warehouse picking accuracy: clear OE reference labeling reduces selection errors across similar mirror glass variants.
• Box-level issuing: 1 unit per box supports clean workshop distribution and lowers handling risk.
• Fleet maintenance readiness: suitable for scheduled visibility repairs on regional and long-haul operations.
• Stable aftermarket supply: supports consistent replenishment cycles for compatible heavy-duty platforms.

1. Park on level ground, apply the parking brake, and secure the vehicle.
2. Switch off ignition and disconnect the battery if required by your workshop procedure.
3. Protect paint and trim around the mirror housing with a soft cloth.
4. Check the OE reference on the removed unit and confirm the mounting configuration.
5. Warm the mirror surface slightly if needed to reduce clip/adhesive resistance.
6. Release retaining points evenly and remove the damaged mirror glass carefully.
7. Clean the seating area and remove debris that could cause uneven loading.
8. Dry-fit the new glass to verify outline match and guide point alignment.
9. Press-fit the glass evenly until fully seated; do not force one corner first.
10. Inspect edge seating for consistent contact and stable positioning.
11. Adjust the mirror angle and confirm a steady view at idle and during a short test.
12. Record the OE reference on the job card to support repeat ordering and traceability.

In most cases, the replacement is straightforward and can be completed with no special tools required, maintaining plug-and-play compatibility expectations for service work and supporting a clean direct-fit installation when OE reference and mounting configuration match.

This page is provided for aftermarket identification and service replacement based on OE reference matching and confirmation of the mounting configuration on the vehicle. Fitment should be confirmed by OE reference and mounting configuration before ordering.

• Material performance: engineered for stable clarity and durability in commercial vehicle use, including frequent wash cycles and high-mileage service.
• Optical intent: curvature and viewing geometry are designed to support clear rearward visibility without claiming certification or approval markings.
• Installation compatibility: direct-fit seating depends on correct interface match, alignment points and secure perimeter contact.
• OE references covered: 0028118933, 0028116333, A0028118933, A0028116333.

Compatible with MERCEDES-BENZ ACTROS MP4, ANTOS, AROCS.