pjc46e101k85cd5brq mudguard compatible with FORD F-MAX

pjc46e101k85cd5brq mudguard is a precision-engineered replacement designed to fit applications compatible with FORD F-MAX, helping restore wheel-arch protection in high-mileage service. Referencing part number PJC46E101K85CD5BRQ, it is commonly selected when the previous guard shows vibration damage, cracked edges, or loosened mounting points after depot maneuvering and daily route work.

The pjc46e101k85cd5brq mudguard is shaped to maintain dimensional tolerances along the arch line, using an impact-resistant housing approach to handle debris strikes and road spray. The contact edges are designed to support moisture ingress protection and reduce grime buildup in low-light working conditions, helping keep surrounding body areas cleaner for vehicles compatible with FORD operating in wet weather.

Technicians often choose the pjc46e101k85cd5brq mudguard for direct-fit installation: clean the mounting surface, confirm stable mounting bracket alignment, and verify guide pin alignment (if present). Keep nearby clearances consistent and ensure any wiring harness match paths remain unobstructed. Tighten fixings evenly to avoid stress points, then perform a quick steer lock-to-lock check to confirm the mudguard sits securely without rubbing.

For fleet inventory planning, clear reference labeling improves warehouse picking accuracy and reduces returns when ordering for compatible with FORD F-MAX. Keep PJC46E101K85CD5BRQ visible on cartons for stable aftermarket supply workflows; fitment should be confirmed by reference number and mounting configuration before ordering.

Packing weight: 0.10 KG  •  Quantity in box: 1  •  Quantity in pallet: 0

• SKU planning support: map inventory by PJC46E101K85CD5BRQ for repeat ordering compatible with FORD fleets.
• Warehouse picking accuracy: clear reference marking helps reduce mis-picks and speeds dispatch.
• Transit-ready handling: single-piece panel supports tidy bin storage and safer consolidation.
• Fleet maintenance readiness: suitable for planned replacement cycles on regional distribution trucks.
• Stable supply workflow: supports consistent replenishment for workshops servicing compatible with FORD F-MAX.

1. Preparation: park on level ground, apply the parking brake, and disconnect the battery.
2. Access: turn steering for easier wheel-arch access and remove packed debris.
3. Remove old part: remove fasteners/clips and release the mudguard from the mounting points.
4. Inspect the area: check fastener seats for wear and confirm no cracked tabs remain.
5. Check install points: verify stable mounting bracket alignment and guide pin alignment (if present).
6. Install the new part: align holes, start fixings by hand, then seat the part evenly.
7. Tighten evenly: secure fasteners progressively to avoid stress points and keep consistent gaps.
8. Seal check: confirm edges sit flush to support moisture control around the wheel area.
9. Function check: steer lock-to-lock and confirm no rubbing or movement.
10. Fleet note: record reference PJC46E101K85CD5BRQ for repeat procurement.

This is a direct-fit installation with plug-and-play compatibility for standard mounting points, and no special tools required for routine replacement.