7420862810 mirror glass – compatible with DAF

7420862810 mirror glass is a wide-angle, heated replacement mirror insert designed to restore clear rear visibility on commercial routes and depot yard maneuvers. Based on OE references 7420862810, 20862810, and 1736879, it is commonly listed for applications compatible with DAF (LF45, LF55, CF75, 95XF), compatible with RENAULT TRUCKS (Midlum, Premium, Premium 2, Kerax, Kerax 2, C Series, D Series), and compatible with VOLVO (FE, FL). Fitment should be confirmed by OE reference and mounting configuration before ordering.

Built for everyday fleet service, the 7420862810 mirror glass supports stable reflection geometry and reduced distortion in the wide-view zone, helping drivers monitor blind spots during lane changes, roundabouts, and urban delivery stops. The heated element is intended to improve usability in cold mornings and wet weather where condensation or icing can reduce mirror clarity.

In workshop terms, the 7420862810 mirror glass is typically used as a clip-on insert: technicians focus on correct seating, even pressure around the edges, and clean mounting surfaces to prevent vibration. Common replacement triggers include cracked glass, surface pitting, loss of reflectivity, or heating performance drop caused by connector or contact wear.

For stocking and maintenance planning, this cross-reference set (7420862810 / 20862810 / 1736879) helps reduce picking errors across mixed fleets and improves turnaround time for mirror repairs. Packing weight is listed as 0.80 kg per unit, with 1 piece per box.

• OE references covered: 7420862810, 20862810, 1736879
• Type: wide-angle mirror glass insert, heated element
• Typical mounting: clip-on insert (verify mounting shape before installation)
• Use cases: distribution routes, urban delivery, long-haul lane monitoring
• Packing: 0.80 kg, 1 piece per box

• Fleet maintenance readiness: keep mirror glass inserts on hand to reduce downtime after breakage.
• SKU planning: OE-linked labeling helps workshop teams match 7420862810 quickly during scheduled checks.
• Warehouse efficiency: single-piece boxing supports fast picking and lower damage risk in transit.
• Cross-fleet coverage: one reference set supports mixed vehicles compatible with DAF, compatible with RENAULT TRUCKS, and compatible with VOLVO.
• Repeatable procurement: consistent packing weight and unit count simplify reorder cycles.

• 1. Park safely and switch ignition off; fold mirror housing if your vehicle setup allows.
• 2. Wear cut-resistant gloves and protect the housing to avoid scratches during removal.
• 3. Carefully pry the old mirror glass insert from the carrier (even pressure at multiple points).
• 4. If equipped, disconnect the heater contacts and inspect terminals for corrosion or looseness.
• 5. Clean the mounting surface and confirm the new insert matches the mounting configuration.
• 6. Reconnect heater contacts, then press the new insert into place until it seats evenly.
• 7. Adjust mirror angle, test for vibration, and verify heating function where applicable.
• Typical install time: 10–20 minutes depending on access and housing type.

• Designed around stable mounting geometry and controlled reflection behavior for daily service conditions.
• Heating functionality depends on vehicle wiring and connector condition; verify contact fit during installation.
• Dimensional targets support OEM-style installation interfaces for consistent seating and reduced vibration.
• OE references shown are for identification and fitment confirmation: 7420862810, 20862810, 1736879.

Compatible with LF45, LF55, CF75, 95XF, D Narrow Series, D Wide Series, Premium, Premium 2, Kerax, Kerax 2, Midlum, C Series, FL, FE.