5802287200 exterior mirror compatible with IVECO S-WAY

5802287200 exterior mirror is a right-hand service replacement mirror assembly engineered for fleet use on applications compatible with IVECO S-WAY and compatible with IVECO X-WAY (2021+). Fitment should be confirmed by OE reference and mounting configuration before ordering. Based on OE references 5802287200 and 5802985715, this unit is intended to restore stable visibility for lane changes, depot maneuvering, and tight yard positioning.

Built for high-mileage service, the 5802287200 exterior mirror typically relies on an impact-resistant housing, a stable mounting bracket, and a sealed connector interface (when electrical functions are present) to support moisture ingress protection in wet weather. Mirror clarity and vibration control matter on regional distribution trucks, where wind buffeting and repeated wash cycles can accelerate wear at clip points, fasteners, and hinge interfaces.

During installation, technicians usually focus on guide pin alignment, bracket seating, and wiring harness match to ensure plug-and-play compatibility with the vehicle specification. The 5802287200 exterior mirror can help reduce vibration blur and intermittent operation caused by loose fixings or burnt connector pins, especially after minor impacts or repeated folding. Always check dimensional tolerances at the mounting surface and confirm free movement through the adjustment range before returning the truck to service.

For fleet inventory planning, keeping the 5802287200 exterior mirror clearly labeled by OE reference improves warehouse picking accuracy and reduces downtime when a mirror is damaged. If your workshop manages SKU pairing (RH/LH) across cab variants, cross-check the listed OE references 5802287200 / 5802985715 to keep mirror sets consistent across the fleet and support stable aftermarket supply.

• SKU consolidation by OE reference improves receiving speed and warehouse picking accuracy.
• Clear OE identification supports correct issue-to-workshop for mixed S-WAY / X-WAY fleets.
• Protective packaging helps reduce handling damage to mirror housings during internal transfers.
• Suitable for scheduled visibility checks and rapid replacement after minor depot contact.
• Supports RH/LH pairing strategy for consistent fleet appearance and service planning.

Packing weight: 1.08 kg
Quantity in pallet: 0
Quantity in box: 1

1. Preparation: park safely, apply the parking brake, and follow workshop safety procedures.
2. If electrical functions are present, disconnect the battery before handling connectors.
3. Confirm OE references 5802287200 / 5802985715 and verify the RH mounting configuration.
4. Support the mirror assembly to prevent strain on the bracket while loosening fasteners.
5. Unplug the connector (if equipped) and remove the old mirror assembly carefully.
6. Inspect the mounting surface for cracks, loose inserts, or vibration damage and clean the seating area.
7. Install the new unit with guide pin alignment and ensure flush bracket seating.
8. Tighten fasteners evenly and secure the wiring path to avoid chafing.
9. Check seal integrity around the housing and connector area for moisture ingress protection.
10. Function check: verify adjustment movement and stable visibility with no vibration blur.
11. Fleet note: record the OE reference on the job card for faster repeat ordering.

When OE reference and mounting geometry are matched, no special tools required, plug-and-play compatibility, and direct-fit installation are typically achieved for workshop replacement.

• Material performance: impact-resistant housing and stable bracket interfaces designed for commercial vehicle vibration exposure.
• Visibility design intent: mirror geometry supports consistent field-of-view performance for day/night operation without claiming certification.
• Installation compatibility: confirm OE reference and mounting configuration; ensure secure seating and sealed connector interface where applicable.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

Compatible with IVECO S-WAY (2021+) and compatible with IVECO X-WAY (2021+) (all listed OE references).