418850 step pedal grill compatible with FORD F-MAX LH

418850 step pedal grill is a precision-engineered under-step grille panel for the LH side, designed to fit vehicles compatible with FORD F-MAX and help protect the step area from spray, grit, and impact exposure. It is commonly used when the existing panel becomes loose from vibration damage, the edge line cracks, or mounting seats distort after repeated depot maneuvering and long-haul route operation.

The 418850 step pedal grill is shaped to maintain dimensional tolerances around the mounting line, supporting stable bracket alignment and consistent clearances. The surface helps manage moisture runoff and reduce dirt packing beneath the step zone, improving day-to-day access in low-light working conditions and wet regional distribution routes for trucks compatible with FORD. Fitment should be confirmed by reference number and mounting configuration before ordering.

Installation is direct-fit: remove the damaged grille, clean contact points, align fastener holes, and tighten evenly to avoid stress points. For fleet inventory planning and warehouse picking accuracy, reference numbers are clearly used: T418850 and JC46E20041AF57MC. This replacement 418850 step pedal grill supports repeatable service cycles without modification for compatible with FORD F-MAX maintenance.

Packing weight: 0.10 KG  •  Quantity in box: 1  •  Quantity in pallet: 0

• SKU planning: keep T418850 / JC46E20041AF57MC visible for repeat ordering compatible with FORD fleets.
• Warehouse picking accuracy: consistent reference labeling reduces mis-picks and returns.
• Transit-ready handling: panel-style component supports tidy storage and consolidation.
• Fleet maintenance readiness: suitable for scheduled step-area refresh cycles on high-mileage units.
• LH/RH stocking logic: supports pairing strategy when mirrored access parts are managed.

1. Preparation: park safely, apply the parking brake, and disconnect the battery.
2. Clean the step area: remove mud/grit so fasteners can be accessed.
3. Remove old grill: undo fasteners and release the panel from the bracket line.
4. Inspect mounting points: check clips/holes for wear and correct any deformation.
5. Test-fit: confirm hole alignment and consistent edge seating.
6. Install new part: position the grill and start fasteners by hand.
7. Tighten evenly: secure progressively to avoid stress points.
8. Final check: confirm stable seating and no contact with adjacent trim.

This is a direct-fit installation with plug-and-play compatibility for standard mounting points, and no special tools required for routine replacement.