1088198 mirror brace – Compatible with VOLVO F10 / F12 (1977–1994, L.H.)

1088198 mirror brace – Description

1088198 mirror brace is a left-hand (L.H.) support component for door mirror mounting used on vehicles compatible with VOLVO F10 / F12 platforms. OE reference: 1088198. Fitment should be confirmed by OE reference and mounting configuration before ordering.

In commercial operation, mirror stability is a daily safety factor: vibration, wind load, and repeated adjustments can gradually stress the mirror support area. When a brace is bent, cracked, or loosened, drivers may notice mirror shake at speed, drifting alignment after adjustment, or uneven gaps at the mounting interface. This 1088198 mirror brace is intended to restore rigid support at the mounting points so the mirror assembly remains steady during highway vibration and frequent cab-side contact. Because mirror assemblies can vary by cab spec and bracket geometry, always match the physical mounting layout to the OE reference 1088198 before installation.

For workshop service, replacement is straightforward: support the mirror assembly, remove fasteners, clean the contact surfaces, and install the new brace with even torque to prevent preload. After mounting, verify full adjustment range and confirm that the mirror head sits square without twisting. This helps reduce repeated re-tightening and improves long-term stability for fleet maintenance routines. Packing weight: 0.10 kg. Quantity per box: 1.

Bulk Purchase Benefits

Box quantity: 1 pc (helps reduce picking errors and supports OE-based labeling).

Packing weight: 0.10 kg (lower handling effort for storage and line-side service kits).

Recommended B2B practice: store by OE reference 1088198 and side (L.H.) to avoid cross-side mix-ups.

DIY Replacement Guide

■ Common reasons to replace

■ Mirror shake at speed or increased vibration on uneven roads

■ Mirror alignment drifts after adjustment

■ Visible cracking, bending, or wear around fastener points

Install checklist (L.H.)

● Support the mirror assembly before removing fasteners.

▲ Clean the mounting faces and check for burrs or uneven seating.

■ Tighten evenly, then verify adjustment range and stability.

OE reference: 1088198.

Compliance Statement

This aftermarket 1088198 mirror brace is intended for maintenance and replacement use where OE reference and mounting geometry are used to confirm application.

Fitment should be confirmed by OE reference and mounting configuration before ordering.

Fit & Application Verification

Compatible with VOLVO F10 / F12 (1977–1994)