Skip to product information
1 of 1

XKLAMP

RC4613W030AC head lamp – Compatible with FORD F-LINE (2023-)

RC4613W030AC head lamp – Compatible with FORD F-LINE (2023-)

Head Lamp compatible with FORD F-LINE

Direct-fit replacement lighting compatible with FORD F-LINE (2023-) | Built for fleet, workshop, and long-haul use

RC4613W030AC head lamp – Description

RC4613W030AC head lamp is a direct-fit replacement designed to be compatible with FORD F-LINE (2023-) applications where the original headlight unit has suffered lens damage, weakened illumination, or housing wear from daily route vibration. The RC4613W030AC head lamp supports reliable fitment around the mounting points and helps restore consistent road visibility for workshop and fleet maintenance.

In commercial operation, a headlight often needs replacement after stone impact, crack propagation, moisture ingress, or broken tabs that cause misalignment. The RC4613W030AC head lamp is commonly selected when technicians want a predictable installation flow: remove the old unit, transfer any compatible fittings, secure the new lamp evenly, and verify connector engagement to reduce intermittent lighting issues.

For parts identification and picking accuracy, the RC4613W030AC head lamp may also be listed with a single cross reference for verification: T436301 — use VIN/spec confirmation and physical comparison when required by your workshop SOP.

To keep your vehicle compliant with local roadworthiness checks, always confirm beam aim and lighting function after installation (low beam/high beam/position light if applicable). Keeping RC4613W030AC head lamp stock on hand can reduce downtime during scheduled inspections and seasonal visibility checks, especially for depots operating mixed routes and night deliveries.

RC4613W030AC head lamp compatible with FORD F-LINE front view RC4613W030AC head lamp compatible with FORD F-LINE installed reference

Bulk Purchase Benefits

MOQ
1 Unit
Supports trial orders & service stock
Workshop efficiency
Direct-Fit
Faster replacement during service windows
Fleet readiness
Plannable
Useful for scheduled inspections and depot stock
Packing Weight
0.10 KG
Listed spec for logistics planning

DIY Replacement Guide

!
Symptom-Based Replacement (visibility drop, condensation, broken tabs, unstable aim)
!
Reduced night visibility or uneven beam pattern
!
Water inside housing after rain or wash
!
Loose housing / cracked mounting points from vibration
  1. Switch off ignition; follow workshop SOP for battery isolation if required.
  2. Remove trim/access panels carefully and keep fasteners organized.
  3. Disconnect the lamp connector; inspect pins for corrosion or heat marks.
  4. Unbolt the unit; support it to avoid stressing brackets.
  5. Install the new part; tighten evenly and confirm panel gaps.
  6. Test lighting function and adjust aim following your local procedure.

Compliance Statement

Usage & responsibility notice

• This is an aftermarket replacement part designed to be compatible with the listed vehicle application
• Always confirm OE number, connector type, and mounting geometry before installation
• Beam aiming and roadworthiness checks must follow local regulations and workshop procedures

Important Note: Left/right units are not interchangeable. Confirm side and configuration before ordering.
View full details