81251016582 head lamp is designed for dependable illumination and reliable fitment on vehicles compatible with MAN TGA / TGL / TGM applications commonly seen in EU fleet service. Built around controlled dimensional tolerances, it supports consistent mounting alignment to help maintain a stable beam pattern after replacement.

81251016582 head lamp is engineered with an impact-resistant housing concept and a sealed connector interface approach to reduce moisture-related issues when installed correctly. The optical layout focuses on reflector geometry and beam cutoff control principles for clearer road illumination and reduced scatter, supporting safer night operation for commercial routes.

81251016582 head lamp is a practical replacement choice when the lens is hazed, the unit has internal fogging, or vibration has compromised aiming consistency. In workshop routines, confirming mounting points, connector orientation, and levelling type before installation can reduce downtime and avoid repeat handling.

81251016582 head lamp ships as a single unit (Quantity in Box: 1; Quantity in Pallet: 0) with a packing weight reference of 3.25 kg. For best results, verify application by chassis/VIN and check side orientation (LH/RH) prior to ordering, especially when managing paired fleet inventory.

Replacement Direct-fit Plug-and-play Fleet maintenance

● SKU consolidation support: keep one clear reference for service planning
● OE reference printed for faster picking and fewer receiving mismatches
● Box protection helps reduce handling marks during warehouse movement
● Suits annual fleet maintenance cycles and damage-repair stock holding
● Distributor-friendly: repeatable reorder workflow for workshop supply

When to replace:

• ■ Dull output, uneven beam, or frequent aiming drift
• ■ Lens haze, cracks, or internal moisture/fogging
• ■ Broken mounts or vibration causing misalignment

Service steps (typical workshop flow):

• ● Switch ignition off, secure vehicle, disconnect battery
• ● Remove access trim/grille panels as required
• ● Unplug connector, inspect pins for corrosion/heat marks
• ● Remove fasteners, replace unit using existing mounting points
• ● Reconnect, function-check, then adjust aim/levelling

Install is typically direct-fit and plug-and-play on matching connectors and brackets; no special tools required beyond standard hand tools for access panels. Always confirm side (LH/RH) and connector type before final tightening.