500305106 head lamp – Compatible with IVECO Eurostar/Eurotech 1992-2002

500305106 head lamp – Description

500305106 head lamp is a direct-fit replacement lighting unit designed for dependable workshop service on vehicles compatible with IVECO Eurostar and compatible with IVECO Eurotech (1992-2002). The 500305106 head lamp is commonly replaced when the lens is clouded, the housing is cracked, or the seal has aged and allows moisture to fog the reflector, helping restore safer visibility for night routes and wet-weather operation.

For identification and picking accuracy, record Part No. 500305106 during removal and check the mounting tabs and connector alignment before installation. The 500305106 head lamp is typically supplied as a right-side unit (RH position), supporting faster turnaround for fleet maintenance when downtime needs to be minimized and light performance must remain consistent across repeated service cycles.

To support catalogue matching in distributor inventories, a secondary cross reference used for the same fitment family is 4861342. The 500305106 head lamp should always be confirmed by vehicle configuration (left/right position and steering layout), because head lamp variants may share similar housings while using different brackets, aiming adjusters, or connector keys that can affect installation time and return rates.

For shipping and storage planning, the 500305106 head lamp is packed as 1 unit per box, with a packing weight of approximately 3.91 kg, and quantity in pallet listed as 0 in single-unit logistics records. Keeping the 500305106 head lamp in stock as a routine replacement helps reduce last-minute sourcing during inspections and supports planned preventive maintenance for commercial fleets.

MOQ: 50 units
B2B Terms: NET 30
Volume Pricing: >100 units: 12% discount

Packing Weight: 3.91 KG
Quantity in Box: 1
Quantity in Pallet: 0

Bulk-ready support for fleet maintenance: consolidated labelling, box-level protection, and simplified depot replenishment for compatible with IVECO lighting repairs.

■ Symptom-Based Replacement
■ Dim or scattered beam output during night driving
■ Lens fogging after rain or wash-bay cleaning
■ Broken mounting points causing vibration or misalignment

Steps (workshop-friendly):
1) Park safely, switch off ignition, and disconnect the battery negative terminal.
2) Remove surrounding trim/grille sections as needed to access the lamp fasteners.
3) Unplug the connector and inspect pins for looseness or corrosion.
4) Remove mounting fasteners while supporting the lamp housing.
5) Install the unit evenly, tighten fasteners, test functions, then complete final aiming.

• Supplied as an aftermarket replacement component for maintenance and repair use in commercial vehicle service.
• Materials and structure are selected to support stable mounting under vibration and reliable day-to-day operation.
• Fitment control: verify left/right position and steering layout prior to ordering; vehicle-ID confirmation is recommended for mixed fleets.

Compatible with IVECO Eurostar, IVECO Eurotech, IVECO Eurotrakker.